How do I load a design?

How do I load a design?

Using the STANDARD Controller: 

  1. Insert the design disk into the floppy disk drive
  2. Press the EMB.CALL button
  3. Press the DOWN button to access the FDD CALL command
  4. Press the SET button
  5. The machine will display all of designs located on the floppy disk
  6. Scroll to the desired design name by using the UP or DOWN button
  7. Press the SET button
  8. The line SELECT EMPTY ROOM will appear on the screen followed by a number.
  9. Unless a change is necessary, press the SET button
  10. Press the PREVIOUS button twice
  11. Your design is loaded into memory

Using the LCD Controller:

  1. Insert the design disk into the floppy disk drive
  2. Press the INPUT button (F1)
  3. Press the FLOPPY button (F1)
  4. Press the UP ARROW button (F1) or the DOWN ARROW button (F2) to highlight the desired design
  5. Press the COPY button
  6. Unless a change is necessary, press the SELECT button (F7)
  7. Press the PREVIOUS button (F8)

 

    • Related Articles

    • LED - Load a design on the standard control panel

      How do I LOAD a design on the standard control panel? Insert the design disk into the floppy disk drive. The floppy disk drive is located on the right side of the control panel. Press the EMB.CALL button or (IN-OUT button) Press the green DOWN button ...

    • LED - Clear a design

      How do I CLEAR a design that is currently on my machine in the standard control panel?  Press the STOP button. Hold down the SET button until the machine beeps rapidly and the LCD screen blinks "Design End Code"

    • Tray bed does not load all the way.

      Why doesn't my tray bed load all the way. Reasons and Solutions: 1. Flashing Load button indicates laser has stopped the loading **Eject the tray bed and check the height of the platen. Adjust as necessary and reload. Prevention: Always check the ...

    • How do I rotate a design?

      Using the STANDARD Controller: Load the design as normal Press the SETTING button Press the DOWN button twice to access the ANGLE command Press the SET button Change the setting by typing in the desired angle; i.e. 180 Press the SET button Press the ...

    • LCD - Copy a design to disk

      Question: How do I copy a file from the machine memory to a floppy disk? Using the LCD Controller: Press the INPUT button (F1) Press the OUTPUT button (F2) Press the FLOPPY button (F1) Use the LEFT ARROW (F1), UP ARROW (F2), DOWN ARROW (F3) and RIGHT ...