LED - CAP and FLAT settings

• Related Articles

• Switch the machine Cap and Flat settings

  Using the STANDARD Controller: Press the MACHINE button. Press the DOWN button The "2) Machine Function" command will be highlighted. Press the SET button. The "1. Flat, Cap: Flat" command will be highlighted. Press the SET button. The machine will ...

• Viper Default Menu Settings

  The Attached PDF cover the Viper Default Menu Settings.

• LED - Clear a design

  How do I CLEAR a design that is currently on my machine in the standard control panel?  Press the STOP button. Hold down the SET button until the machine beeps rapidly and the LCD screen blinks "Design End Code"

• LED - Basic setting

  How do I put in my basic setting on the standard control panel? Go to 1. BASIC SETTING Press the SETTING button. Using the DOWN key to 3. Angle the input 0-for Flat and 180- for Caps. Press the SET button.

• LED - Backup a few stitches

  How do I BACKUP a few stitches in my design in the standard control panel? The design must be loaded and stopped. Press the TRIM button. Press the START button. If yo would like, pull the presser foot down until it snaps into position. This may help ...