LED - Copy a file to disk

LED - Copy a file to disk

How do I COPY a file from the machine memory to a floppy disk in the standard control panel?

Click the FDD button. You will be highlighting "1) FFD SAVE" command.

Press the SET button. Find the desired design by using the UP or DOWN buttons on the LCD menu indication screen. When the design is highlighted press the SET button.

You will be given the option of choosing "1.SWF or 2.TAJIMA". For this example press the DOWN button to access the "2.TAJIMA" command.

Press the SET button. After the design has completed being copied to the floppy disk, press the PREVIOUS button.

NOTE: If a copy of the design is currently located on the disk, you will be prompted "Over write Design? OK=>SET, NO=>PREV". To that question you will have to decide in which way to proceed.

    • Related Articles

    • LCD - Copy a design to disk

      Question: How do I copy a file from the machine memory to a floppy disk? Using the LCD Controller: Press the INPUT button (F1) Press the OUTPUT button (F2) Press the FLOPPY button (F1) Use the LEFT ARROW (F1), UP ARROW (F2), DOWN ARROW (F3) and RIGHT ...

    • LED - Clear a design

      How do I CLEAR a design that is currently on my machine in the standard control panel?  Press the STOP button. Hold down the SET button until the machine beeps rapidly and the LCD screen blinks "Design End Code"

    • LED - Basic setting

      How do I put in my basic setting on the standard control panel? Go to 1. BASIC SETTING Press the SETTING button. Using the DOWN key to 3. Angle the input 0-for Flat and 180- for Caps. Press the SET button.

    • Not previewing or printing graphic file

      White Quality Queue was not generating preview or printing it. The print mode was set to White 1440x720 hs instead of just 1440x720 hs.

    • LED - CAP and FLAT settings

      How do I SWITCH the machine between CAP and FLAT settings in the standard control panel? Press the MACHINE button. Press the DOWN button. The "2) Machine Function" command will be highlighted. Press the SET button. The "1.Flat, Cap: Flat" command ...