LED - How do I rotate my design?

• Related Articles

• LED - Clear a design

  How do I CLEAR a design that is currently on my machine in the standard control panel?  Press the STOP button. Hold down the SET button until the machine beeps rapidly and the LCD screen blinks "Design End Code"

• How do I rotate a design?

  Using the STANDARD Controller: Load the design as normal Press the SETTING button Press the DOWN button twice to access the ANGLE command Press the SET button Change the setting by typing in the desired angle; i.e. 180 Press the SET button Press the ...

• LED - Enlarge or shrink my design

  How do I ENLARGE or SHRINK my design in the standard control panel? Load the design as normal. Press the SETTING button. You will see highlighted "1) X Scale: 100%. Press the SET button. You can type in any percentage increase or decrease you would ...

• LED - Load a design on the standard control panel

  How do I LOAD a design on the standard control panel? Insert the design disk into the floppy disk drive. The floppy disk drive is located on the right side of the control panel. Press the EMB.CALL button or (IN-OUT button) Press the green DOWN button ...

• LED - Basic setting

  How do I put in my basic setting on the standard control panel? Go to 1. BASIC SETTING Press the SETTING button. Using the DOWN key to 3. Angle the input 0-for Flat and 180- for Caps. Press the SET button.