LED -Increase the Satin Width

LED -Increase the Satin Width

How do I INCREASE the Satin Width on a design in the standard control panel?

Load the design as normal. Press the SETTING button.

Press the DOWN button on the LCD menu indication screen to access the X SATING command (#6).

Press the SET button. The machine will display X SATIN: 0[RANGE 0-5]. These numbers represent the degree to which all satin columns within the design will be increased horizontally.

Type in your choice; i.e. 2. Press the SET button.

Press the DOWN button to access the Y SATIN command (#7). Press the SET button.

Press the SET button. The machine will display Y SATIN: 0[RANGE 0-5]. These numbers represent the degree to which all satin columns within the design will be increased vertically.

Type in your choice; i.e. 2. Press the SET button.

Press the PREVIOUS button twice.

    • Related Articles

    • Increase the satin width on a design

      Using the STANDARD Controller: Load the design as normal Press the SETTING button Press the DOWN button to access the X SATIN command (#6) Press the SET button The machine will display X SATIN: 0 [RANGE 0 5] These numbers represent the degree to ...

    • LED - Clear a design

      How do I CLEAR a design that is currently on my machine in the standard control panel?  Press the STOP button. Hold down the SET button until the machine beeps rapidly and the LCD screen blinks "Design End Code"

    • LED - Basic setting

      How do I put in my basic setting on the standard control panel? Go to 1. BASIC SETTING Press the SETTING button. Using the DOWN key to 3. Angle the input 0-for Flat and 180- for Caps. Press the SET button.

    • LED - CAP and FLAT settings

      How do I SWITCH the machine between CAP and FLAT settings in the standard control panel? Press the MACHINE button. Press the DOWN button. The "2) Machine Function" command will be highlighted. Press the SET button. The "1.Flat, Cap: Flat" command ...

    • LED - Backup a few stitches

      How do I BACKUP a few stitches in my design in the standard control panel? The design must be loaded and stopped. Press the TRIM button. Press the START button. If yo would like, pull the presser foot down until it snaps into position. This may help ...