Serial to Serial input on 1501T Wilcom Deco 2 software

Use a Gigaware 6 foot cable 232 to db-9 (Radio Shack Part Number#26-1402)

 

 

and a null modem adapter (Radio Shack Part Number 26-1411).

 

 

1) Software set is 38400 baud rate, Data bit 8, Stop Bit 1, Handshake = Hardware.

 

Sending to Machine:

 

1) Clear all designs from Embroidery machine.

2) With design already up on screen, click on stitct to stitch.

3) Set machine to SWF.

4) Click ok transfer.

5) Go to control panel on Embroidery Machine & Click on Serial input

6) Copy. 

 

How to from Mike Lowe of DJM Embroidery

• Related Articles

• RipPro C5 Software Download

  Download RipPro C5 Software Click Here Download RipPro C5 Extraction Instructions Click Here Download RipPro C5 Installation Instructions Click Here Download RipPro C5 Printer Package Setup Click Here Download RipPro C5 Manual Click Here

• Set input parameters for reading Tajima designs

  When reading a Tajima design from any source (floppy, CD, file), you will need to insure the proper code settings so that the trims and color changes are correctly imported. This is called the Machine Code Interpreter. This setting can be found under ...

• DTG Printer Support - Validating Rip Pro Software

  The DTG (Direct to Garment) Validating Rip Pro Software manual in PDF format.

• How to input from USB flash drive with your CAMS 1V 2P

  How to input from USB flash drive with your CAMS 1V 2P

• Reciprocator Replacement for Multiheads (B-Series)

  Please see the attached pdf for instructions on how to replace the reciprocator on a B-Series Multihead